Re: "IEEE 1394 Bus host controllers" doesn't appear in Device manager



Hannatime9
07-09-2005, 09:59 PM
I am having the same problems, where is the dip switch and how do you
enable it? Thank you.


Bill Wrote:
> I found the problem. It turns out that the card has a dip
> switch for disabling the FW port. It was supposed to
> default to enabled from the factory. Upon checking it I
> found it Disabled. Enabled it and it works fine. Thanks
> for help.
> -----Original Message-----
> Try uninstalling and then reinstalling the ATI drivers.
>
> Cari
> www.coribright.com
>
> "Bill" catman915@insightbb.com wrote in message
> news:018b01c35b87$e2962870$a601280a@phx.gbl...
> Thanks Cari. It isn't a firewire card per se. It's an
> ATI
> Radeon 8500-DV video card with/Capture which is supposed
> to accept DV in from camcorders. It has the jack for DV.
> It works fine with comp & SVideo in.
> -----Original Message-----
> They should have been installed automatically when you
> installed the card.
> Can you turn off the PC, physically remove the card,
> then
> turn on the PC....
> then turn off the PC again and reinsert the card, turn
> on
> the PC and ensure
> XP installs the drivers... (yes, I know this isn't
> possible if the firewire
> port is attached to the motherboard - in that case go
> to
> the motherboard
> manufacturer's website and see if they have updated
> drivers.
>
> Cari
> www.coribright.com
>
> "Bill" catman915@insightbb.com wrote in message
> news:0d5801c35b68$fef87cd0$a601280a@phx.gbl...
> I am trying to capture video from Camcorder DV output
> but
> cannot see camera in app. How do I install 1394
> support
> drivers in Windows XP? Thanks
>
>
> .
>
>
>
> .
>


--
Hannatime9


Re: "IEEE 1394 Bus host controllers" doesn't appear in Device manager