My BEFSR41v1 (firmware 1.46.02) router is setup a my LANs DHCP server.
I have 4 PCs receiving IPs from it. 3 are wireless PCs and 1 wired.
Only the wired PC shows up in the DHCP client table. Even after I click
the refresh button it will only show the wired PC. Other than this
issue, all PCs can ping one another and all PCs can access the Internet.
Sooner Al [MVP]
07-10-2005, 02:55 AM
I would post this to the Linksys forums on the Broadband Reports site. This is not an XP issue...
http://www.dslreports.com/forum/linksys
It probably has something to do with your actual wireless access point since the BEFSR41, as you
know, is a wired only device.
--
Al Jarvi (MS-MVP Windows Networking)
Please post *ALL* questions and replies to the news group for the mutual benefit of all of us...
The MS-MVP Program - http://mvp.support.microsoft.com
This posting is provided "AS IS" with no warranties, and confers no rights...
"d28" <kevindu28@yahoo.com> wrote in message
news:1117974900.729047.286180@g43g2000cwa.googlegroups.com...
> My BEFSR41v1 (firmware 1.46.02) router is setup a my LANs DHCP server.
> I have 4 PCs receiving IPs from it. 3 are wireless PCs and 1 wired.
> Only the wired PC shows up in the DHCP client table. Even after I click
> the refresh button it will only show the wired PC. Other than this
> issue, all PCs can ping one another and all PCs can access the Internet.
>