[Nicolas]

Hi,

I'm having some trouble with my image. When I build an image, then I
first deploy it to my second hard disk and run the FBA to see that
everything is ok. After that, I copy the image to my CompactFlash card
and boot my device. I first let FBA run, so that all the drivers would
be installed. During FBA I get the message that the file
'compbatt.sys' could not be located. I don't get this message when I
deploy the image to my second hard disk.

Best regards,

Nicolas

[KM]

Nicolas,

This is weird.
I suppose "Microsoft Composite Battery" component is in your image, right? Can you check whether the compbatt.dll is in your pre-FBA
image just before you deploy it on CF?

Btw, this may not be a good idea to run FBA on CF card. It is recommended to run the image through FBA on hard disk and then
transfer the image properly to the CF.

--
KM,
BSquare Corp.
www.bsquare.com


> Hi,
>
> I'm having some trouble with my image. When I build an image, then I
> first deploy it to my second hard disk and run the FBA to see that
> everything is ok. After that, I copy the image to my CompactFlash card
> and boot my device. I first let FBA run, so that all the drivers would
> be installed. During FBA I get the message that the file
> 'compbatt.sys' could not be located. I don't get this message when I
> deploy the image to my second hard disk.
>
> Best regards,
>
> Nicolas

[Gereon]

Funny, I saw this just last night, trying to get UPS support added in for
the first time. I added HID UPS Battery, and it complained about
Compbatt.sys missing (and it was, indeed, missing from the image). But I
added Microsoft Composite Battery and it went away.

"KM" <konstmor@nospam_yahoo.com> wrote in message
news:elW8yRpcFHA.4040@TK2MSFTNGP14.phx.gbl...
> Nicolas,
>
> This is weird.
> I suppose "Microsoft Composite Battery" component is in your image, right?
> Can you check whether the compbatt.dll is in your pre-FBA image just
> before you deploy it on CF?
>
> Btw, this may not be a good idea to run FBA on CF card. It is recommended
> to run the image through FBA on hard disk and then transfer the image
> properly to the CF.
>
> --
> KM,
> BSquare Corp.
> www.bsquare.com
>
>
>> Hi,
>>
>> I'm having some trouble with my image. When I build an image, then I
>> first deploy it to my second hard disk and run the FBA to see that
>> everything is ok. After that, I copy the image to my CompactFlash card
>> and boot my device. I first let FBA run, so that all the drivers would
>> be installed. During FBA I get the message that the file
>> 'compbatt.sys' could not be located. I don't get this message when I
>> deploy the image to my second hard disk.
>>
>> Best regards,
>>
>> Nicolas
>
>