Re: AAEON 6892 board



Netpwm
07-09-2005, 09:23 PM
From the details,
the one beep indicate that the system is working and you should see the
startup screen, the problem is in the BIOS setting, you are probable using
LCD as the display, try to connect an external monitor you should see
display, from there set the BIOS to CRT+LCD

"Paulox" wrote:

> Hi,
>
> I'm not used to AAEON boards but I work for one of its competitors.
>
> This issue can occur if in the BIOS settings, the Video output is
> configured to "PCI First" instead of "M/B" or "Internal".
>
> So what I suggest would be to take another PCI VGA board and try to boot
> the Motherboard again. You should get a display that would allow you to
> enter the BIOS and change the settings.
>
> Regards,
>
> Paulox
>
> "J.S." <juergen.striegel.remove_me@acd-elektronik.de> wrote in message
> news:ehwcEoKUFHA.3280@TK2MSFTNGP09.phx.gbl...
> > emkay schrieb:
> >> Does any one has any experience with AAEON 6892 board? I purchased it
> >
> > I've exactly the same board here with a running XPE :-)
> >
> >> AAEON 6892 Rev A 1.0
> >> 256MB SDRAM 133Mhz
> >> ATX Power Supply
> >
> > Switch back to "AT power supply" in BIOS. Use a "Standard PC" component.
> > This is working fine for me.
> >
> > Juergen
>
>
>

emkay
07-09-2005, 09:24 PM
Well, the problem was with the VGA connector cable. 6892 uses a
different pinout assignment. Got the proper cables and got it working.


Re: AAEON 6892 board