Re: AAEON 6892 board



Netpwm
07-09-2005, 09:23 PM
From detail provided,
the one beep, indicate that the system is ok, and you should see the start
up screen, the problem is the setting in the BIOS, you are probable using LCD
as the display, try to connect a external monitor to the VGA port and than
set the BIOS to used CTR+LCD



"Paulox" wrote:

> Hi,
>
> I'm not used to AAEON boards but I work for one of its competitors.
>
> This issue can occur if in the BIOS settings, the Video output is
> configured to "PCI First" instead of "M/B" or "Internal".
>
> So what I suggest would be to take another PCI VGA board and try to boot
> the Motherboard again. You should get a display that would allow you to
> enter the BIOS and change the settings.
>
> Regards,
>
> Paulox
>
> "J.S." <juergen.striegel.remove_me@acd-elektronik.de> wrote in message
> news:ehwcEoKUFHA.3280@TK2MSFTNGP09.phx.gbl...
> > emkay schrieb:
> >> Does any one has any experience with AAEON 6892 board? I purchased it
> >
> > I've exactly the same board here with a running XPE :-)
> >
> >> AAEON 6892 Rev A 1.0
> >> 256MB SDRAM 133Mhz
> >> ATX Power Supply
> >
> > Switch back to "AT power supply" in BIOS. Use a "Standard PC" component.
> > This is working fine for me.
> >
> > Juergen
>
>
>


Re: AAEON 6892 board